How to Get Backup Camera Out Subaru
Having a backup camera in your Subaru is a convenient feature that helps you park and maneuver in tight spaces. However, there might be situations where you need to remove the backup camera for various reasons, such as maintenance or installation of aftermarket accessories. In this article, we will guide you through the process of how to get the backup camera out of your Subaru.
Before you begin, it is essential to gather the necessary tools and materials. You will need a flathead screwdriver, a T20 Torx screwdriver, and a small phillips screwdriver. Additionally, ensure that you have a clean and well-lit workspace to avoid any accidents or damage to the camera.
Step 1: Locate the Backup Camera
The backup camera is typically located on the rear of the Subaru, either on the bumper or the tailgate. Check your vehicle’s manual to confirm the exact location of the camera. Once you have located it, you can proceed to the next step.
Step 2: Disconnect the Power
Before attempting to remove the backup camera, it is crucial to disconnect the power to prevent any electrical damage. Locate the battery in your Subaru and disconnect the negative terminal using a wrench or socket. This step ensures that there is no power flowing to the camera during the removal process.
Step 3: Remove the Mounting Screws
Using the flathead screwdriver, gently remove the protective cover or trim that may be covering the mounting screws of the backup camera. Once the cover is removed, locate the T20 Torx screw and the small phillips screw that secure the camera to the vehicle. Use the appropriate screwdriver to remove these screws.
Step 4: Disconnect the Camera
With the mounting screws removed, gently pull the backup camera away from the vehicle. Be cautious as there may be electrical connections or cables attached to the camera. Once the camera is loose, disconnect any cables or connections that are holding it in place.
Step 5: Remove the Camera
With all connections disconnected, carefully remove the backup camera from the Subaru. Depending on the model and year of your vehicle, the camera may be attached to the vehicle with additional clips or brackets. Use your hands or a flathead screwdriver to release any additional attachments and carefully lift the camera out of the vehicle.
Step 6: Clean and Store the Camera
After removing the backup camera, it is essential to clean the camera and any mounting areas to ensure a smooth installation if you need to put it back. Use a soft cloth and a mild cleaning solution to wipe down the camera and mounting area. Once clean, store the camera in a safe place to prevent damage or loss.
In conclusion, removing the backup camera from your Subaru is a straightforward process that requires patience and the right tools. By following these steps, you can safely remove the camera for maintenance, installation, or any other reason. Always refer to your vehicle’s manual for specific instructions related to your Subaru model.
